Application Temperature	Above 40 degreesF (4 degreesC)
Service Temperature Range	0 degreesF to 160 degreesF (-18 degreesC to 71 degreesC)
Method of Application	Cartridge/caulking gun
Working Time	Approximately 10-15 minutes for 1/4 inches bead
Application Directions:
Cartridge	1. Surfaces must be clean and free of any material that may prevent adequate adhesion. Properly designed joint not to exceed 1/2 inches in dept 2. Cut tip at 45 degrees angle for 1/8 inches to 1/2 inches bead and place in cartridge gun. 3. Apply caulk into clean joint. If necessary, smooth bead immediately. It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability.
Painting	The caulk should be dry to the touch and ready to paint in 2-4 hr with a water-based (latex) paint that does not contain plasticizer.
Cleanup	Clean uncured material with water. After curing, excess caulk must be cut or scraped away.
1/8 inches Bead Coverage	123 feet
1/4 inches Bead Coverage	31 feet

1/2 inches Bead Coverage	8 feet
Limitations	Not designed for continuous submersion or use below the waterline. Air, caulk and surface temperature should be above 40 degreesF. Do not apply if rain is expected within 12 hours Cure time is dependent upon ambient conditions including temperature and humidity. The caulk should be dry to the touch and ready to paint in 2-4 hr with a water-based (latex) paint that does not contain plasticizer. For other paint types, a compatibility test is recommende It is highly recommended to use backing materia For best results, store in a dry location at or below 75 degreesF.
Type	Siliconized acrylic
Calculated VOC	10.1 ounces Cartridge
Solids	80%
Flashpoint	Solvent free/Not applicable
Viscosity	140,000 cps
Freeze / Thaw Stability	Stable
Storage Life	24 months in a dry location at or below 75 degreesF.